? ?Basic Parameters?:
PCB: 54mm x 85.5mm x 11mm (without the size of connectors, switches)
?Measurement Frequency: 50KHz-300MHz (50KHz -900MHz, enable extended firmware)
?RF Output: -13dbm (maximum -9dbm)
?Frequency Accuracy: ?0.5ppm
Measurement Range: 70dB (50kHz-300MHz), 50dB (300M-600MHz), 40dB (600M-900MHz) ?enable extended firmware)
?Port SWR: < 1.1
?Display: 2.8 inch TFT (320 x240)
?USB Interface: USB Type-C; Communications Mode: CDC (Serial)
?Power Supply: USB 5V 120mA, built-in 400mAh electricity, maximum ?charging current 0.8A
?Number of Calibration Points: 101 (Fixed)
?Number of Scanning Points: 101 (Fixed)
?Display Tracking: 4, Marking: 4, Save Setting : 5
?Measuring S parameters, voltage standing wave ratio, phase, delay, ?Smith chart and the like
?Language:English & Chinese
1 x NanoVNA Main Unit
1 x USB Type-C Data Cable
2 x 30cm SMA Male to Male RG174 RF Cables
1 x SMA Calibration Kit Male
1 x SMA Female to Female Connector
??Friendly Notes ? :
I. To save the shipping time and make sure you can receive the parcel, please leave your contact information, including your name, address (country, province / state, city name, street), telephone number, postal zip code. We also promise to protect customers' private information - Friendgo Online Shop Team
II: Size: All sizes are measured by the workers. There is a little difference about 1-3CM. Please do not worry, it's normal.
III: Color: The color in the picture is for reference only. There is a small difference with authentic items because of the limitation of photography equipment, different screen and light. Hope to get your understanding.
IV: Because we ship our items from China, it may Delivery time takes 15-20 days. I hope you can understand it. Thank you.
? It is a DIY vector network analyzer. It features a 2.8-inch touchscreen, 400mAh electricity for off-line application in 2 hours.
? If you want to prolong the testing time, you can connect it to an extra power bank, or contact us for larger capacity.
? As for testing via TX/RX, you can get full set of parameters of S11 and S21. What you have to do is to replace the connection cables in the receiving and transmitting ports.
? Measurement Frequency: 50KHz-300MHz (50KHz -900MHz, enable extended firmware)
? Measurement Range: 70dB (50kHz-300MHz), 50dB (300M-600MHz), 40dB (600M-900MHz) enable extended firmware) Port SWR: < 1.1